Boat Cleaner, Salt Wash and Surface Protection

Salty Muck, by Motomuck, safely removes salt and grime from your marine-going vessel. And when used at the recommended dilution (250:1), it leaves a water sheeting nano-protective coating behind that is resistant to streaking and spots. Safe to use on any surface including aluminium, fiberglass, steel, magnesium, chrome, plastic and rubber, Salty Muck can be used on boats, kayaks, PWC’s, trailers, 4x4's, dive gear, fishing tackle and surfaces exposed to corrosive salt. As a highly concentrated, low-foaming biodegradable cleaner, you can use Salty Muck for regular maintenance and washes to increase the longevity and function of your equipment for years to come.

Contains: Plant derived surfactants and emulsifiers, antimicrobial preservatives, water sheeting agents.

NB: Prior to application, test the product on a hidden spot to ensure compatibility. No liability will be accepted.

CLEANING AND WASHING - Application and Dilution:

We recommend the following Motomuck units (sold separately) to apply a diluted ratio of Salty Muck to your boat or equipment. Agitate heavy grime if necessary.

Hose Foam Gun - Use 20% Salty Muck with 80% water, then set gun at:
- #0 on dial / 135:1 = to get a 675:1 final ratio for LIGHT muck.
- #1 on dial / 45:1 = to get a 250:1 recommended ratio for REGULAR WASHING. This ratio will apply the nano-protective water sheeting coating.
- #2 on dial / 25:1 = to get a 125:1 final ratio for HEAVY muck.

Snow Foam Gun for pressure washers - Use 10-20% Salty Muck with 80-90% water.
- Adjust the dial on the Snow Foam Gun all the way to the right. If there are too many soap suds, turn the dial back towards the left.

Engine Flush Mixer with hose nozzle attachment - Use 100% Salty Muck in the reservoir cup.
- Start with the dial turned to OFF (minimum WATER dial option) and once tap is turned on, turn the dial to SOAP. If needed, you can reduce the amount of soap by adjusting the dial.
- Ensure you hose off all soap properly, with fresh water, before allowing the surface to dry. To rinse off with water, just adjust the dial to WATER.

ENGINE AND COOLING FLUSH - Application and Dilution:

Motomuck Engine Flush Mixer (sold separately):
- Up to 90hp motor = Add 50ml Salty Muck into the mixer reservoir cup. Attach the mixer to flush muffs or flush port, turn the dial to SOAP, turn on water and flush according to your motors recommendations (approx 2-5mins).
- 90hp - 300hp motor = Add 80ml Salty Muck into the mixer reservoir cup. Attach the mixer to flush muffs or flush port, turn the dial to SOAP, turn on water and flush according to your motors recommendations (approx 2-5mins).

SOAKING GEAR AND EQUIPMENT - Application and Dilution:

In a large, clean container - Mix 120ml of Salty Muck per 4 litres of fresh water. Soak gear or equipment. Rinse with fresh water.

motomuck